Stainless steel pipe cap profile:
Stainless steel pipe cap is also called the plug or head.
Purpose: welding on the pipe end or installed outside the pipe thread to
cover wall pipe fittings. Close to line, the same as the plug.
Pipe cap including convex cap, conical shell, variable diameter section,
the design of the flat cover and tighten.
Convex tube caps include: hemispherical tube cap, oval tube caps, disc pipe
cap and QiuGuanXing cap. From the standpoint of stress, convex cap in the
gradually from hemispherical tube cap is not good, but look from the
manufacturing difficulty, good manufacture gradually.
304 l stainless steel: 304 316 316 l, 321, 2520, 310, 316, such as
Size: DN15-48 ") wall thickness: SCH5 - SCH160 standard: ASME DIN JIS BS
GB/T, JB SH HG USES: water, beverages, beer, food, petrochemical, nuclear power,
chemical fertilizer, shipbuilding, machinery, medical equipment, waterproof
processing, pipeline, etc
Packing: packed in wooden cases, cartons service: provide technical advice,
installation guide, etc
Splice weld direction when asked to only allow is radial and ring. After
large cap may cancel this request. Stitching distance requirements, for more
than 3 g, and not less than 100 mm (welding heat affected zone is high stress
zone, and in the chemical composition of the area will be a loss. So to avoid
the high stress area, the area and thickness. According to the practical
experience, the stress attenuation length is greater than 3 g, and not less than
100 mm). But refrigeration equipment is difficult to meet the requirements, has
We have adopted advanced production equipment and technologies to
manufacture our pipe elbows and pipe bends,which can not only improve product
quality, but also save raw materials. Our products have high strength, good
toughness and resistance to corrosion.